spa2102 phone codes

Code Description

****
Enter the star key four times to hear the Interactive Voice Response Menu. Do not press any
other keys until you hear the Linksys configuration menu. Please enter the desired menu option
followed by the # (pound) key or hang up to exit.

100# DHCP Client status (i.e. whether or not unit obtains IP via DHCP). On the adapter, this will
announce WAN connection type.

101# Change DHCP Client. Options are 0 for Static IP, 1 to enable DHCP. On the adapter, there is also
option 3 for PPPoE.

110# Announce IP address of your adapter. On the adapter, this will announce the WAN IP address.
(Note: have a pen & paper handy)

111#
Assign adapter a static IP address. On the adapter, this will change the WAN IP address. Enter the
IP address, replacing dots in IP with the star key, and ending the entry with #. For example, the IP
address 192.168.0.10 would be entered as 192*168*0*10#

120# Announce Netmask of your adapter . On the adapter, this refers to the WAN netmask.

121# Set netmask of adapter, similar to static IP above. For example, the netmask 255.255.255.0 would
be entered as 255*255*255*0#

130# Announce Default Route of your adapter

131# Set default route, similar to static IP above. For example, the route 192.168.0.1 would be entered
as 192*168*0*1#

140# Check MAC Address. Hear the MAC address of the Phone Adapter in hexadecimal string format.

150# Gives firmware version

160# Announce primary DNS server

161#
Set Primary DNS Server IP Address. Enter the IP address using numbers on the telephone
keypad. Use the * (star) key when entering a decimal point. Before setting this, set the Internet
Connection Type to static IP address; otherwise, you will hear “Invalid Option".

170# Check Internet Web Server Port. Hear the port number of the Internet Web server used for the
Web-based Utility.

131# Set primary DNS server, similar to static IP above.

201#
Set the router mode.
Press 0 to select the NAT mode. Press 1 to select the bridge/switch mode.
If the phone adapter acts as the router for your network, use the router/NAT mode.
If your network already has a router, use the bridge/switch mode.

210# Announces LAN IP for adapter

7932#
Enable/Disable WAN Access to the Web-based Utility.
Press 1 to enable. Press 0 to disable.
Use this setting to enable or disable WAN access to the Web-based Utility. (This Utility lets you
configure the Phone Adapter.)

723646# Controls whether or not the Web Admin Access is enabled. 1 is enabled, 0 is disabled.

73738# Factory Default the adapter (only on unlocked units)

732668#Manual Reboot. After you hear "Option successful", hang up the phone. The Phone Adapter will
automatically reboot.

877778#
User Factory Reset. Press 1 to confirm. Press * (star) to cancel.
The Phone Adapter will request confirmation; enter 1 to confirm.
You will hear "Option successful". Hang up the phone. The Phone Adapter will reboot and all
user-configurable settings will be reset to their factory default settings.